Product Manual

49
Assembly Instructions
Step 6 – Suction Hose to Hydraulic Tank
• Locate the shortest piece of suction hose and the appropriate sized
hose clamp as shown below.
• Slide one end of the suction hose thru the inside hole of the engine
mount bracket.
• Loosen hose clamp as necessary. Slide hose clamp onto end of suction
hose and push hose onto elbow.
• Secure and tighten hose clamp around the suction hose and elbow.
Torque to50 in.-lb.
• Hose clamp must have a tight seal to prevent hydraulic oil from
leaking.
• Allow suction hose to hang loose until further direction.
Tools Needed
• Flat Blade Screw
Driver
• Torque Wrench
Tank to Hydraulic Pump Hose
Suction Hose, 14” x 3/4” ID
Qty 1, Model 110800 Only
Tank to Hydraulic Pump Hose
Suction Hose, 17.5” x 1” ID
Qty 1, Model 110900, 1131 Only
Suction Hose
Inside Hole of
Engine Mount Bracket
Elbow
(already installed)
Hose Clamp
Tow Bar
Tank to Pump Hose Clamp
Qty 1
110900 and 1131 Only
Tank to Pump Hose Clamp
Qty 1
110800 Only
Fasteners Needed from Parts Bag:
Hoses Needed: