Product Manual

Assembly Instructions

Step 17 – Valve Installation

• Remove plug from cylinder port and discard

• Lubricate O-ring and threads on fitting with clean oil

• Orientate (1) Valve Fitting so that nut/washer/O-ring assembly is

facing up. Turn fitting into cylinder port until finger-tight

• Torque to 27-43 ft.-lb.

• Looking at fitting from end with nut/washer/O-ring assembly, turn nut

clockwise as far as possible

• Use valve port marked “A” to thread the control valve onto the fitting

until control valve touches washer

• Hold control valve in orientation shown below and torque nut to 37-46

ft.-lb.

Tools Needed

• 7/8” Wrench

(2 needed)

• Crescent Wrench

(2 needed)

• Torque Wrench

Hydraulic

Control Valve

Straight Fitting

Fig05026

Cylinder

Straight Fitting

Cylinder Port

Nut

Washer

O-Ring

Part # 790488

Valve Fitting

Qty: 1

Into

Cylinder

Fitting Needed from Parts Bag: