Product Manual

Assembly Instructions

Step 15 – Engine Guard to Beam

NOTE: Engine guard installation varies for all models due to engine size

Assemble to engine guard to the beam in the horizontal position

• Align engine guard bracket to the two sets of holes in the beam

• Slide the vinyl coated clamp located on throttle cable to the hole on the

engine guard shown below. See next page for correct clamp location.

• 110800 Only: Using (4) bolts, (4) nuts and (4) washers, secure engine

guard to beam.

• 110900 & 1131 Only: Using (4) bolts, (4) nuts, and (3) washers, secure

engine guard to beam. Secure vinyl coated loop clamp from previous

step to underside of beam as shown. Do not use washer on bolt used to

secure loop clamp.

• Torque to 20 ft.lb. CAUTION: Over-tightening can crush tube.

Tools Needed

• 13mm Wrench

(2 Needed)

• Torque Wrench

Engine Guard to Beam

Flange Bolt

Qty 4

Engine Guard to Beam

Nyloc Nut

Qty 4

Engine Guard to Beam

Flat Washer

110800 Qty 4, 110900 &

1131 Qty 3

Note: Models 110800 &

110900

Engine guard curves

downwards

Beam

Engine Guard

Note: Model 1131 shown

Engine guard curves upwards

Nut

Bolt

Secure vinyl

coated loop

clamp to this

bolt.

Washer

Fasteners Needed from Parts Bag: