Product Manual

14
Before Each Use: Step One: Inspection / Maintenance
Step One: Inspect and Maintain log splitter before each use
If the log splitter has been used previously, it must be inspected and maintained BEFORE EACH SUBSEQUENT USE.
WARNING
ALWAYS shut off the engine, disconnect the spark plug, and relieve system pressure
before inspecting, cleaning, adjusting, or repairing the splitter. Relieve system pressure by
moving Split Control Lever back and forth several times.
IMPORTANT:
If a part needs replacement, only use parts that meet the manufacturer’s specifications. Replacement parts that do not
meet specifications may result in a safety hazard or poor operation of the log splitter.
1. Engine off/relieve
pressure
Perform all inspections/repairs with the engine off and hydraulic system pressure
relieved.
1. Make sure engine is off and cool.
2. Disconnect the spark plug.
3. Relieve all hydraulic system pressure by moving the Split Control Lever and the Log
Lift Control Lever back and forth several times.
2. Remove debris
Remove debris from engine, muffler, and moving parts.
1. Engine debris. Debris on a hot engine can be a fire hazard. Clean debris and chaff
from engine cylinder head, cylinder head fins, blower housing rotating screen, and
muffler areas. Avoid contact with hot muffler.
2. Other debris. Debris on moving parts can cause excess wear. Clear debris from the
slide beam, ram, and wedge.
3. Fuel tank/lines
Check fuel tank and fuel lines for leaks.
Any fuel leak is a fire hazard. Fix any fuel leaks before starting engine.
4. Mechanical parts
Check to be sure all nuts and bolts are tight to make sure the log splitter is in safe working
condition.
5. Hydraulic system
Check the hydraulic system carefully:
1. Visually inspect all hoses, tubing, clamps/fittings, pump, and cylinder for cracks,
fraying, kinks, or other damage.
2. Check all components for oily residue, which may indicate a leak.
DO NOT operate the log splitter if there is any indication of damage or oily residue. Small
leaks in hydraulic lines can cause severe injuries and can also be an indication of
catastrophic failure in the near future. The life of hydraulic hoses may be from a few months
to a few years, depending on use and storage patterns.
WARNING: High fluid pressures and temperatures are developed in hydraulic log
splitters. Hydraulic fluid escaping through a pin hole sized opening can burn or
puncture skin, resulting in wounds that could cause blood poisoning, infection,
disability, gangrene, amputation, or death. Therefore, the following instructions
should be heeded at all times when inspecting or servicing the hydraulic components
of the log splitter: