Product Manual

8
Initial Unpacking & Set-Up
1. Step One: Add
engine oil
Add oil to the engine.
Using a funnel, add SAE 10W-30 oil up to the FULL mark on the dip stick.
(See engine Owner’s Manual for oil capacity and location of fill cap.)
2. Step Two: Secure
Split Control
Lever
Secure the Split Control Lever in the operating position. Use following
procedures:
1. The Split Control Lever is shipped taped to the hydraulic cylinder. Untape to
release.
2. Raise lever until hole in lever aligns with the 2 holes on the control valve
bracket. Insert the clevis pin through the aligned holes.
3. Insert the bridge pin into the protruding end of the clevis pin..
3. Step Three:
Inspect log splitter
components
Closely inspect all splitter components.
(See Machine Components section of this manual on p. 7 for diagram of
components.)
● If you have any missing or damaged components, please contact Product Support at
1-800-270-0810.
IMPORTANT!
Engine is shipped without oil. DO NOT start the engine before adding oil.
Bridge Pin
Clevis Pin