Product Manual

Assembly
20
4. Verify connection
Verify a complete connection has been made by checking with a DC voltmeter,
or by briefly turning the remote switch to the ON position and listening for pump
activation.
5. Attach remote
switch to vehicle
Using supplied Hook & Loop pad, affix remote switch to vehicle in a position
that is easily reached from the driver's seat.
6. Attach sprayer to
vehicle if haven't
yet
If you have not yet mounted the sprayer to your vehicle, do so at this time
following the instructions in "Step 9: Attach Sprayer to Vehicle".
7. Disconnect after
use
AFTER EACH USE, disconnect power to the sprayer by disconnecting
the remote switch from the pump power plug – the remote switch may remain
connected to the battery.
NOTE: It is important to disconnect power to the sprayer when not in use for
safety reasons. ALWAYS verify that the power has been disconnected or the
remote switch is in the OFF position before adding chemicals or servicing.
8. To disconnect
permanently
When it is necessary to disconnect the sprayer’s remote switch from
the battery, use the following procedure:
1. Disconnect sprayer’s pump cord from the remote switch.
2. Disconnect the remote switch from the vehicle battery as follows:
a) Disconnect vehicle battery ground wire.
b) Disconnect the remote switch’s black battery clamp from the
negative(-) terminal of the vehicle battery.
c) Disconnect the remote switch’s red battery clamp from the positive(+)
terminal of the vehicle battery.
d) Reconnect the vehicle battery ground wire.
WARNING: Always disconnect in this sequence to avoid possible shock.
(Remember that on some vehicle models, you may need to remove the
sprayer to access the battery)