Product Manual

3
STEP 2
• Secure generator on blocks at least 7”
tall. Make sure the space between the
holes for the axle is not obstructed.
STEP 3a
Item # 165620 only
1. Remove 5/16” x 2” bolt, star washer, flat washer
and 5/16” nut from generator base.
2. Attach axle mount to frame reusing 5/16” x 2”
bolt, star washer, 5/16” washer, in addition to
5/16” x 3/4” bolt and 5/16” nuts as shown.
3. Attach second axle mount on to frame, repeating
axle to frame fastener installation.
4. Install one wheel retainer onto axle so it is flush
with the axle end. Tighten with a 5/32” hex
driver.
5. Slide one wheel onto the axle, so that the offset
hub is opposite the wheel retainer.
6. Slide one axle washer onto axle
7. Slide the axle through the holes on both axle
mounts.
8. Slide the second axle washer onto axle.
9. Slide the second wheel on to the axle.
Wheel offset hub should face the
generator.
10. Install other wheel retainer onto axle so it
is flush with the axle end. Tighten with a
5/32” hex driver.
Note: Tires may require periodic inflation.
Ref.
Part #
Description
1
82021
5/16” washer (reuse from gen.)
2
82301
Star washer (reuse from gen.)
3
791834
Axle
4
788813
Wheel
5
305200
Wheel retainer
6
82018
5/16” x 2” bolt (reuse from gen.)
7
785395
Axle mount
8
82019
5/16” flange nut
10
82015
5/16” x 3/4” bolt
23
791782
Axle Washer