Product Manual

Installation / Initial Set-Up
20
Step 4:
Remove spark plug(s) or spark
plug wire(s) before working on
the engine or generator to
prevent accidental starting.
Install the Rotor Stud into the
rotor through the hole in the
middle of the bearing support
and torque to 16 ft lbs. To
keep the engine from turning
have a helper pull and hold the
engine’s recoil start rope.
Thread the green grounding
screw from the manual bag into
the grounding hole on the cross
bracket of the non-drive end
bracket.
Rotor
stud
Step 5:
Position the end cover
onto the generator by
rotating the cover so that
the L-shaped slots will
latch onto the screw
heads. Press plug
(included in the manual
bag) into the hole in the
center of the end cover.