Product Manual

Installation / Initial Set-Up

Mounting

generator to engine

Step 1:

Attach the Engine Adapter

plate to the mounting face

of the engine using the

hardware supplied with the

generator head. Before

tightening the bolts make

sure the adapter plate is

flush against the engine’s

machined surfaces near the

mounting holes. Torque

the bolts to 16 ft lbs.

Misalignment will cause

generator failure.

WARNING:

ALWAYS shut off the engine and disconnect the spark plug(s) before installation or

servicing the generator. Make sure all guards and shields are replaced before using.

Step 2:

Carefully slide the

generator head onto the

shaft of the engine. Torque

the bolts from the manual

bag to 7.5 ft lbs.

After the bolts are tight,

use a wood block and

“dead-blow” hammer to tap

on the bearing support area

of the non-drive end

bracket (do not damage the

capacitor with hammer).

This will ensure the

bearing is properly seated.

Capacitor

Step 3:

Use the remaining bolt & nut

from the manual bag to secure

the non-drive end bracket.

Slide the head of the bolt into

the U-shaped slot on the

bottom of the non-drive end

bracket. Align the bottom of

the bolt with the existing

isolation bracket. Tighten nut

to secure the generator head.