Product Manual

Troubleshooting

WARNING

Before troubleshooting or attempting to service, read the following safety rules to

avoid accidental exposure to chemical and also risk of electric shock.

Before attempting to service the sprayer:

1. Personal

protective

equipment

Wear personal protective equipment as directed on the chemical label while

servicing your sprayer.

2. Review

troubleshooting

table

Review the Troubleshooting Table below for the type of problem you are

experiencing. However, DO NOT attempt to repair until the steps listed below

are followed.

3. Disconnect

power/relieve

pressure

Turn off the sprayer and be sure all system pressure is relieved.

4. Perform repairs

Follow the directions provided in the troubleshooting table to repair the

broadcast kit.

NOTE: Never try to unclog a broadcast nozzle by blowing through it.

5. Test after

servicing

After servicing, ALWAYS test the sprayer and broadcast kit for leaks with

plain water before using.

PROBLEM

CAUSE

SOLUTION

Solenoid valve will not operate

Bad electrical connection

Check battery connections

Short in wires

Check condition of wires

Low voltage

Check voltage

Poor spray distribution

Nozzle(s) oriented incorrectly

See assembly instructions

Suction strainer clogged

See Sprayer Owner’s Manual

Worn broadcast nozzle

Replace broadcast nozzle