Product Manual

Operation - Using the Sprayer (continued)
27

5. Operate spray
gun (as needed
for application)
To spray, rotate the handle of the spray gun.
-Rotating the handle will change the spray pattern from OFF, to cone, to
stream.
Note: It is not unusual for the operator to be exposed to chemical while
operating the spray gun– gloves should be chemical resistant.
6. Leaving
unattended
If the sprayer must be left unattended at any time:
a) Disconnect power to the sprayer.
b) Relieve system pressure by depressing the gun trigger.
c) Turn off the vehicle. Set brake or block the wheels.
7. Discontinue use if
clogged or
inoperative
If the sprayer becomes clogged or inoperative during use, discontinue use
immediately.
- DO NOT attempt to service while chemicals are in the sprayer and power is
connected.
- Return to service area to review instructions for troubleshooting before
attempting to service.
Note: A reserve, clean container capable of holding at least 26 gallons should be kept for use when
the sprayer tank needs to be emptied temporarily for repairs. It is advisable to purchase a
reserve tank suitable for pesticide storage from Northern Tool and Equipment for use in these
circumstances. The container should be properly labeled as to its contents if it is used.