Product Manual

Assembly (continued)

Step Six: Attach suction hose and agitation hose

1. Install hose clamps on hose.

i) Slide hose clamp over the end of the hose.

ii) Push the hose onto the hose barb.

iii) Slide the hose clamp over the hose barb.

iv) Tighten the hose clamp

2. Using the 1/2" hose clamps, attach one end of the Agitation hose to the agitation tube.

3. Attach the other end of the Agitation hose to the Outlet tee barb.

4. Using the 3/4" hose clamps, attach one end of the suction hose to the suction tube.

5. Attach the other end of the suction hose to the inlet barb.

Step Seven: Prepare spray gun

1. Attach the threaded end of hose barb into the gun inlet.

2. Unthread the nozzle nut and discard the standard orifice disk.

3. Position the extended throw nozzle as shown. Note: keep the plastic gasket in its original position.

4. To secure the extended throw nozzle, thread the nozzle nut back onto the gun.

Agitation hose

Suction hose

Outlet tee barb

Agitation tube

Suction tube

Inlet barb

Hose barb

Extended

throw

nozzle

Nozzle nut

Plastic gasket

Standard orifice disk