Product Manual

Installation (continued)

3. Connect pump

to battery

Connect the pump to a 12V DC battery using the following procedure:

a) Disconnect the vehicle battery ground wire.

b) Connect the pump’s red wire to the positive (+) terminal of the battery.

c) Connect the pump’s black wire to the negative (-) terminal of the

battery.

d) Reconnect the vehicle battery ground wire.

Note: Skip steps (a) and (d) if battery is not in a vehicle.

WARNING: Always connect in this sequence to avoid possible shock.

4. Disconnect

after use

AFTER EACH USE, disconnect power to the pump using the following

procedure:

a) Disconnect the vehicle battery ground wire.

b) Disconnect the pump’s black wire from the negative (-) terminal of

the battery.

c) Disconnect the pump’s red wire from the positive (+) terminal of the

battery.

d) Reconnect the vehicle battery ground wire.

Note: Skip steps (a) and (d) if battery is not in a vehicle.

WARNING: Always disconnect in this sequence to avoid possible shock.

NOTE: It is important to disconnect power to the pump when not in use for

safety reasons. ALWAYS verify that the power has been disconnected before

adding chemicals or servicing.

Note: A remote switch is recommended for temporarily shutting off the pump’s operation.

Call NorthStar Product Support at 1-800-270-0810 to order NorthStar item #94992.

Negative

(black wire)

Positive

(red wire)