Installation & Assembly

Distributed exclusively in the United States by
North States Industries, Inc.
5455 Highway 169 N
Plymouth, MN 55442
www.northstatesind.com
Rev 12/2017
Manufactured in
Guang Dong, China
Remove the vertical bar from one end on the
extension and the panel you wish to connect. Turn
clockwise to loosen and pull down to remove.
Note: If applicable, remove the Socket Cap E.
To connect the panels together, vertically lift one
panel allowing the upper and lower hinge housings
to slip into place in the mating panel.
Insert the vertical
bar into recess of
lower hinge mount.
Press “A” down and
slide it into upper
hinge.
Turn counter-
clockwise to tighten.
Step 1. Step 2.
Step 3.
Please refer to the instruction manual for additional installation information.
Page 2