Integration Guide

GEM3 Module Hardware Integration Guide Version 0.1
North Pole Engineering
221 N 1st St, Minneapolis, MN 55401
www.npe-inc.com
612.305.0440
6 MECHANICAL INFORMATION
7 SOLDERING GUIDELINES
See the Stencil pattern above for solder paste application. Recommended Stencil thickness is
120um.
8 REGULATORY & STANDARDS INFORMATION
8.1 FCC & INDUSTRY CANADA
The GEM3 module has modular approval for the United States and Canada. To ensure
compliance when using the GEM3 module in a design, the OEM is required to adhere to the
implementation considerations supplied in this hardware integration guide.
8.1.1 Federal Communication Commission (FCC) Radiation Exposure Statement:
This device is in compliance with SAR for general population/uncontrolled exposure limits in
ANSI/IEEE C95.1-1999 and had been tested in accordance with the measurement methods and
procedures specified in OET Bulletin 65 Supplement C.
This transceiver must not be co-located or operating in conjunction with any other antenna,
transmitter, or external amplifiers. Further testing / evaluation of the end product will be
required if the OEM’s device violates any of these requirements.
The GEM3 Module is fully approved for mobile and portable applications.
8.1.2 FCC/IC Labeling Requirements
WARNING: The OEM must ensure that FCC labeling requirements are met. This includes a
clearly visible label on the outside of the OEM enclosure specifying the appropriate FCC / IC
identifier.
Contains FCC ID: XRH-NPE105
IC: 11922A- NPE105
If OEM device is larger than 8x10cm, the following FCC part 15.19 statement has to be visible on
outside of device:
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause undesired operation.