Datasheet
2
Network protection
• Australia TS038/31/03/04/01
• EU CTR12/13/3/4/21
• North America/CALA FCC Part 68, CS 03 Issue 8
Safety and surge/transient
• Australia TS038/31/02/03/04, ACA TS001, AS/NZS 3260
• NA/CALA/APAC IEC/EN 60950-1 (including all group and national devi-
ations) and CSA C22.2 No. 60950-1, UL60950-1
• EU CTR12/13/3/4/21, EN 60950 (with national deviations)
• United Kingdom EN60950
Telephony components
Media Services Card (BCM-MSC)
• One 8-pin modular jack (RJ-45) connection for Expansion Chassis
(Only on BCM400 not BCM200)
• Four 3.5 mm (1/8 inch) standard miniature stereo (3-conductor)
Safety Extra Low
• Voltage (SELV) jacks for auxiliary ringer, page relay, page output and
music on hold
• Auxiliary ringer switch capacity of 50mA (non-inductive) at 40 V
(maximum)
• Page Relay switch capacity of 50mA (non-inductive) at 40 V
(maximum)
• Page Output 600 ohms impedance
• Music on hold mono input
• Media Services Processor Expansion Card slots
— BCM400—four slots, two equipped
— BCM200—two slots, one equipped
• Supports maximum of 8 DS-30s. Allows 2/6 and 3/5 IP/TDM Splits.
Media Bay Modules features
16 Stn Digital Station Media Bay Module+ (DSM 16+)
• One Amphenol (male) connector (25 pair)
• Individual interfaces are current connector (25-pair); limited to 80 mA
• 16 digital phone ports
• Two LEDs: Power, Status
• Utilizes 1/2 DS-30 (with DIP switch set appropriately)
32 Stn Digital Station Media Bay Module+ (DSM 32+)
• Two Amphenol (male)
• Individual interfaces are current connectors (25 pair); limited to 80 mA
• 32 digital phone ports
• Two LEDs: Power, Status
• Utilizes 1 DS-30 (with DIP switch set appropriately)
8 Stn Analog Station Media Bay Module (GASM 8)
• One Amphenol (male) connector (25 pair)
• Maximum modem connection speed: 28.8 kbps
• 8 analog phone ports
• Loop length 26G 2600 ft, 24G 4000 ft; 22G 6500 ft
• Disconnect Supervision-850 ms. Momentary Disconnect (Open Switch
Interval (OSI) as per TIA/EIA 464)
• Message Waiting Indication — NA 120V. 600 ms On and 1000 ms Off.
UK reverse polarity
• Analog connectivity support for Poland and Australia
• Calling Line Identification (CLID) Name and Number — NA per Bell 202
standard. UK per SIN 227/224.
• Two LEDs: Power, Status
• Utilizes 1/4 DS-30 (with DIP switch set appropriately)
Digital Trunk Media Bay Module (DTM)
• One 8-pin RJ-45C modular jack
• T1 trunk interface with integrated CSU
• 24 B channels with T1 interface (supports DSX-1 and DS1 interfaces)
• 23 B channels with North American PRI interface
• LEDs: Power, Status, In-service, Loop-back, Test, Receive Alarm,
Receive Error, Transmit Alarm, Transmit Error
• 30 digital channels with ETSI PRI Interface
• Utilizes 1 (one) DS-30
Digital Drop and Insert MUX Media Bay Module (DDIM)
• One 8-pin RJ-45C modular jack
• T1 trunk interface with integrated CSU
• 24 B channels with T1 interface (supports DSX-1 and DS1 interfaces)
• LEDs: Power, Status, In-service, Loop-back Test, Receive Alarm,
Receive Error, Transmit Alarm, Transmit Error
• LEDs: Transmit, Receive, RTS, CTS, DCD, DSR, TM
• V.35-DB26 miniature connector
• Cables: V.35, BCM WAN, Nortel Routers, DB-60 cable
• Utilizes two DS-30s
Basic Rate Interface Media Bay Module (BRIM S/T)
• Four modular RJ-45 jacks
• Supports four S/T interfaces (8 B-channels)
• T-interface to connect to an NT1 device or an S-interface to connect
ISDN terminals
• Supports ETSI and National ISDN BRI
• Two LEDs: Power, Status
• Utilizes 1/3 DS-30
Global Analog Trunk Module (GATM 4)
• One Amphenol (male) connector for analog North American, UK and
Australia Standard
• Four loop start CLASS/CMS lines plus one auxiliary port for V.90
modem, fax, analog telephone connection or Power Fail Transfer
• Two LEDs: Power, Status
• Utilizes 1/4 DS-30
Global Analog Trunk Module (GATM 8)
• One Amphenol (male) connector for analog North American, UK and
Australia Standard
• Eight loop start CLASS/CMS lines plus one auxiliary port for V.90
modem, fax, analog telephone connection or Power Fail Transfer
• Two LEDs: Power, Status
• Utilizes 1/2 DS-30
Fiber Expansion Media Bay Module (FEM)
• Six fiber ports
• Connects up to six Norstar* fiber-based trunk or station modules
• Two LEDs: Power, Status
• Utilizes 1 DS-30 for each Norstar fiber trunk or station module
connected (up to 6)
Global 4X16 Module (4 Caller ID trunks + 16 Station sets, G4x16)
• One Amphenol (male) connector (25 pair) to support four loop start
CLASS/CMS lines plus one auxiliary port for V.90 modem, fax, analog
telephone connection, or Power Fail Transfer
• One Amphenol (male) connector (25 pair) to support 16 digital phone
ports
• Individual Station interfaces are current limited to 80mA
• Two LEDs: Power, Status
• Utilizes 1 1/4 DS-30s
Global 8X16 Module (8 Caller ID trunks + 16 Station Sets, G8X16)
• One Amphenol (male) connector (25 pair) to support eight loop start
CLASS/CMS lines plus one auxiliary port for V.90 modem, fax, analog
telephone connection or Power Fair Transfer
• One Amphenol (male) connector (25 pair) to support 16 digital phone
ports
• Individual Station interfaces are current limited to 80mA
• Two LEDs: Power, Status
• Utilizes 1 1/2 DS-30s
ADID Module (Analog Direct Inward Dial 4-Port or 8-Port,
ADID4 and ADID8)
• One Amphenol (male) connector (25 pair) to support four or eight
ADID lines
• Two LEDs: Power, Status
• Utilizes 1/4 DS-30 (ADID4) or 1/2 DS-30 (ADID8)
• Currently North America DID standard