User's Manual

Wallboards

Nortel Networks Call Center Reporting Set Up and Operation Guide Issue 07

5. Select Properties.

6. A window will open with two tabs labelled Settings and Parameters.

Wallboard Settings

The Wallboard Settings window

In Settings, you select whether the Wallboard will be assigned to a Skillset or to the System, the

IP Address of the Wallboard, whether a Title will be displayed and whether a Summary and

Buzzer will be required.

An explanation of each of the Settings is as follows:

Wallboard Assignment

From the drop down menu, select which option the Wallboard is to be assigned. The options are

System, Skill01, Skill02… Skill50 or Not Used. If you have given your Skillsets other names,

these will be displayed in the drop down menu.

IP Address

The Wallboard will have been assigned an IP Address when it was installed. Enter the IP

Address for the Wallboard into this field. The IP Address of each Wallboard must be unique.

You must specify the IP address of the Wallboard, not the network machine name.

Note that the MIS expects the IP Address of the Wallboard to remain constant. If it is altered

then the MIS Wallboard configuration should be amended to match. This will not happen

without manual intervention on a physical Wallboard. However, if the Wallboard is an ipView

SoftBoard running on a PC that uses DHCP to obtain its IP Address, then the IP Address of the

PC could be subject to change. DHCP-enabled PCs usually receive the same IP Address each

time they re-boot.