User's Manual

74 Chapter 8 Global telephony settings
N0060600N0060600
Message reply
enhancement
<check box> Select to enable users to automatically deactivate the message
waiting indicator on analog telephones connected to an analog
station media bay module (ASM), if the reply call from the analog
telephone to the direct dial telephone is answered. Any telephone can
answer the call.
This feature also functions if the user invokes the Call pickup feature
to answer the reply call from the analog telephone. However, it does
not work with the Retrieve parked call feature.
Note: ASM (analog station modules) are not supported in all
countries.
Tips: Only direct dial telephones can send messages (using F1) to
analog telephones connected to an
ASM/GASM. The direct dial set must be the designated direct dial
telephone for the analog telephone receiving a message.
Force auto/spd dial
over ic/conf
<check box> Determine if autodial and speed dial codes can be transmitted during
an active call. This feature works during either a one-to-one call, or
during a conference call.
If selected: When the user presses a programmed autodial or speed
dial key, the system dials out the number while maintaining the
current call.
If not selected: When the user presses a memory key for a speed
dial, the current call is automatically placed on Hold, and the second
call is dialed.
Note: This feature cannot be used for an ad hoc multi-party
conference.
On hold Silence
Tones
Music
Select what a caller hears on an external line when the line is put on
hold.
Silence provides no audio feedback.
Tones provides a periodic tone.
Music provides any signal from a source such as a radio connected
to BCM or streaming audio. See “Selecting the music source” on
page 282.
Held line reminder Immediate
After 30 seconds
After 60 seconds
After 90 seconds
After 120 seconds
After 150 seconds
After 180 seconds
Off
Reminds you that an external call at your telephone is still on Hold.
You periodically hear two tones from your telephone until you take
the call off Hold.
Note: These tones can be heard by the caller.
Delayed ring transfer Off
After 1 ring
After 2 rings
After 3 rings
After 4 rings
After 6 rings
After 10 rings
Defines whether unanswered external calls are forwarded
automatically to a prime telephone after this timer expires.
You must assign a prime telephone for this feature to operate. Refer
to the BCM 4.0 Networking Configuration Guide (N0060606) for
information on how to assign a prime telephone.
Default: After 4 rings
Table 24 Feature settings (Sheet 2 of 3)
Attribute Value Description