User's Manual

Chapter 6 DN records parameters 53
BCM 4.0 Device Configuration Guide
Figure 13 Capabilities and Preferences - Capabilities tab
Table 14 describes the fields on this panel.
Table 14 Capabilities and Preferences - Capabilities tab (Sheet 1 of 3)
Attribute Values Description
Handsfree None
Standard
Auto
None: The handsfree feature is not available on all telephone models (7000
and 7100 digital phones, 2001 IP phones, DMC portables).(Model 7000
phones are supported in Europe only)
Standard: The handsfree feature is activated by pressing a button on the
telephone.
Auto: The handsfree feature is activated when the telephone receives a call.
Note: Handsfree must be enabled on any telephone that allows headsets.
For 7316E digital phones, set Handsfree to Auto.
7406 digital cordless phone: Handsfree must be enabled for this handset to
work.
Speaker volume: Note that the speaker volume returns to the telephone
default setting for each new handsfree call.
Default: Auto
Pickup group None
1 to 9
Assigns this telephone to a pickup group (a group where all telephones ring
until one is answered).
Default: None
Page zone Page zone
(1 to 6)
None
Assigns this telephone to a page zone.
A zone is any group of telephones that you want to group together for
paging, regardless of their location. You can assign one of six zones to
each telephone.
The maximum number of digital telephones in a page zone is 50.
The maximum number of digital and IP telephones in a page zone is 60.
Default: 1
Direct dial Set 1 to Set 5
None
Defines whether you can call the direct dial telephone from this telephone
using the direct dial digit.
Default: 1