User's Manual

46 Chapter 6 DN records parameters
N0060600N0060600
Line Access - Line Assignment tab
Use the line assignment settings to assign physical trunks and target lines to each telephone. Target
lines are used as incoming only. Other lines can be used to both place and answer calls, if they are
configured to do so.
Figure 9 Line Access - Line Assignment tab
Table 10 describes the fields on this panel.
Fwd No
Answer
up to 24 digits Enter the number to which you want to redirect unanswered
incoming calls.
Fwd Delay 2, 3, 4, 6, 10 Define the number of rings before the system forwards an
unanswered call.
This heading only appears after you enter a Call Forward No
Answer number and press Enter.
Default: 4
Fwd Busy up to 24 digits Redirect incoming calls when this telephone is busy with another
call.
Fwd All up to 24 digits This setting is the same as using FEATURE 4 at a telephone. When
this feature is active, all calls to this telephone are forwarded to the
destination entered in this field.
If you are forwarding calls to a remote location, ensure that you
include the required destination/access codes.
A user can press FEATURE #4 to cancel this feature.
Table 10 Telephone line assignment fields (Sheet 1 of 3)
Attribute Values Description
Line <read-only> These are the lines on which this telephone can receive calls. If the
line is a two-way line (DID), the user can also use the line to make
calls.
Also refer to “Configuring Lines” in the BCM 4.0 Networking
Configuration Guide (N0060606).
Table 9 Line Access tab fields (Sheet 2 of 2)
Attribute Value Description