User's Manual

30 Chapter 4 System schedule settings and services scheduling
N0060600N0060600
Restriction and Routing services require a service control password before users are allowed to
change scheduling on a control telephone. The Service Control Password field on this panel allows
you to delete a current entry, and add a new password. Make a note of the password; the panel
displays only asterisks.
Configuring schedule names and timers
The tables on this panel allow you to change the names of the schedules, and to determine when
the schedules, which are set to automatically execute, are deployed. Any changes to these settings
affect all services that use schedules.
Figure 5 Schedule names and timers
Table 3 describes the fields on the subpanel tables.
Table 3 Schedule common settings
Attribute Value Description
Schedules
Schedule <alphanumeric> Double-click the field, and enter a descriptive name for the schedule.
Schedule Times
For each schedule, there are timers for the seven days of the week.
Day <seven days>
Start Time 00:00 to 12:00
a.m.-p.m./24:00
This is the time when the schedule starts, and any previously-running schedules
stop.
Use a 12-hour or 24-hour format. If the entry is less than 12:00, the system
prompts for a day period setting.
00:00 = schedule is off
start and stop are the same = schedule runs for 24 hours
start: 22:00/stop: 06:00 = schedule starts at midnight, runs until 6 a.m., then
starts again at 10 p.m. (22:00).
Stop Time 00:00 to 12:00
a.m.-p.m./24:00
This is the time when the schedule stops.