User's Manual

Chapter 30 Configuring the music source 291
BCM 4.0 Device Configuration Guide
Stream Type G.711 U-Law
G.711 A-Law
G.729
G.723
Default: G.711 U-Law
Enter the codec that is used for the incoming music source audio
stream. The codec you enter here must match the codec used by
the IP Music source.
Frames per packets 1, 2, or 3
Default: 3
Number of audio frames per RTP packet. The number of frames
you enter must match the number of frames per packet sent from
the IP Music source.
RTP port on BCM Default: 2218 Enter the number of the destination port used for the music
source. This is the port BCM uses to send music to the users.
Table 7 Network Device parameters (Sheet 2 of 2)
Attribute Value Description