User's Manual

236 Chapter 27 Display prompts and messages
N0060600N0060600
Conference busy
Conference: You tried to make a conference call, but your system is handling the
maximum number of conference calls (six).
Conf Resrce Full
Silent Monitor: The six conference resources on the system are already occupied.
This is a transient display that reverts to HG Member DN: busy.
Denied in admin
You are trying to use a feature, but do not have access to it under administration.
Last Number redial: The Last Number is not allowed.
Dial voice call
Voice call: Dial the internal number or press the internal auto dial button of the
person to whom you want to speak.
DND from NNN
Prime telephone: The person at telephone NNN has forwarded a call to you using Do
Not Disturb.
DND transfer
Prime telephone: The system has transferred a call to you from a telephone with Do
Not Disturb activated.
DN: Idle
Silent monitor: The current call on the telephone you are monitoring is either not a
Hunt Group call, or the call came in on a line key on that telephone. Note: Lines that
are assigned to the hunt group must not be assigned to individual hunt group
members.
DRT Line001
Prime telephone: No person answered this call, so the system transferred it to you.
Do not disturb
PRIORITY LATER
The telephone you are calling has Do Not Disturb turned on. Press LATER to use the
Ring Again or Messages features, or press
PRIORITY to make a priority call.
Priority Call: The telephone to which you want to transfer the call has Do Not Disturb
active.
Do not disturb
CANCL RETRY JOIN
Transfer: The person to whom you tried to transfer a call has Do Not Disturb active
on their telephone.
• Press JOIN to transfer the call.
• Press RETRY to transfer the call to another person.
• Press
CANCL or the flashing line button to reconnect to the call.
• On 7000 and 7100 digital phones use feature code
FEATURE #70 to cancel the call.
Enter code:
Feature button: If you are checking a speed dial button, enter the two-digit speed dial
code that you want to check.
Enter digits
QUIT OK
Auto dial: Enter the number you want to program, selecting the line first, if necessary,
exactly as if you were placing a call.
Speed dial: Enter the telephone number you want to program exactly as if you were
dialing it normally. When you are finished, press HOLD or
OK.
Enter zone:___
ALL
Page: Enter the required page zone number (0- 6) or press ALL.
Exchanged
Move button: The two buttons you selected have exchanged position.
Expensive route
You have dialed a number, but the least expensive route programmed for the system
is busy. Unless you release the call, the number goes through on a more expensive
route.
F__
QUIT CLEAR
Feature button: Enter the feature code, or press RLS or QUIT to end programming
or
CLEAR to clear the numbers entered. The system accepts the entry when you
enter a valid feature code.
Display prompt Description of error or action