User's Manual

Chapter 18 Configuring telephones: Digital telephones 129
BCM 4.0 Device Configuration Guide
Before you program Call Forwarding on lines on an Embark switch line, ensure that:
• The DTM is configured to DPNSS, and the Host Node switch connection is set to Embark.
• Both real channels and virtual channels are provisioned.
• Routing code or line pool code are programmed for the DPNSS to Embark link.
• Allow redirect check box must be selected. This field is also located under the Capabilities
tab.
During telephone programming for Fwd No Answer and Fwd Busy, when you enter the Forward
to digits, the system performs a validation check with the designated switch. If the validation does
not succeed, the system displays one of the messages shown in Table 39.
Configuring Preferences
The following paths indicate where to configure preferences in Element Manager, and through
Telset Administration:
• Element Manager: Telephony > Sets > Active Sets > Top panel Capabilities and
Preferences tab > Bottom panel - Preferences tab
• Telset interface: **CONFIG > Terminals and Sets
Programming reference:
• “Capabilities and Preferences - Preferences tab” on page 56
• “Job aid: Call log notes” on page 130
Use this panel to specify operational attributes. These attributes can also be set at the telephone.
Settings at the telephone override Element Manager settings.
To configure preferences for a telephone
1 Click Configuration > Telephony > Sets > Active DNs > Capabilities and Preferences tab.
2 Click the Preferences tab in the bottom panel.
3 Call log options: Determine when calls are logged.
4 Dialing options: Determine how the user dials numbers.
Programming note: Some telephones do not allow all dialing options.
5 Contrast: Adjust the contrast level of the display.
Table 39 Embark validation error messages
Message Description
The number is invalid or the destination has
been rejected.
The destination telephone has DND programmed, or it is in a
programming session.
There are no free virtual channels available
for validation.
Either there are not enough channels set up, or no more
channels are available.
Destination may be out of service; no
response received.
The system cannot connect to the remote system.