User's Manual

Chapter 17 Configuring analog telephones and devices 117
BCM 4.0 Device Configuration Guide
ATA answer timer Keep short for modems and
fax machines
“Configuring telephone capabilities” on page 126.
ATA tones check box
ATA use On site
Off site works for devices
connected to ATA modules
only
Msg indicate
ATA device modem/telephone
Disconnect supervision Select for auto-answer
modems and fax machines
Do not select for telephones
The following settings are common settings that are specific to analog telephones.
Handsfree/HF Answerback Do not select “Configuring telephone capabilities” on page 126
Page settings Select check box
Can send pages but cannot
receive pages
Receive short tones Select check box (analog
telephones only)
Hotline “Assigning a pause for
external dialing for data
devices” on page 118
The following settings are not valid (N/V) or are limited on analog devices.
Keep DN Alive N/V “Configuring telephone capabilities” on page 126
SM Supervision Do not select
DND on Busy Do not select
Priority Calls Do not select
Auto hold for incoming page Do not select
Set Link Select check box (telephones
only)
“Outgoing call restrictions” on page 132
All other settings are variable, based on your system requirements.
Table 38 Analog telephone customization (Sheet 2 of 2)
Affected field Setting Panel name and link to common procedures