Network Router User Manual

Web OS 10.0 Application Guide
Chapter 16: Persistence
439
212777-A, February 2002
Configuring SSL Session ID-Based Persistence
To configure session ID-based persistence for a real server, perform the following steps:
1. Configure real servers and services for basic SLB, as indicated below:
n Define each real server and assign an IP address to each real server in the server pool.
n Define a real server group and set up health checks for the group.
n Define a virtual server on the virtual port for HTTPS (for example, port 443) and assign a
real server group to service it.
n Enable SLB on the switch.
n Enable client processing on the port connected to the client.
For information on how to configure your network for SLB, see “Server Load Balancing” on
page 117
2. If a proxy IP address is not configured on the client port, enable DAM for real servers.
3. Select session ID-based persistence as the persistent binding option for the virtual port.
4. Enable client processing on the client port.
>> # /cfg/slb/adv/direct ena
>> # /cfg/slb/virt <virtual server number>/service <virtual port> pbind sslid
>> # /cfg/slb/port <port number>/client ena