Network Router User Manual

Web OS 10.0 Application Guide
360
Chapter 14: Virtual Private Network Load Balancing
212777-A, February 2002
Configure the Second Clean-Side Switch (CB)
1. Turn off bootp.
2. Define and enable VLAN 2 for ports 7 and 8.
3. Turn off Spanning Tree Protocol.
4. Define the clean-side IP interfaces.
Create one clean-side IP interface on a different subnet for each VPN device being load bal-
anced.
5. Configure routes for each of the IP interfaces you configured in Step 4, using the VPN
devices as gateways.
One static route is required for each VPN device being load balanced.
>> # /cfg/sys/bootp dis
>> # /cfg/vlan 2/ena/def 7 8
>> # /cfg/stp/off
>> # /cfg/ip/if 1/ena/mask 255.255.255.0/addr 30.0.0.11
>> # /cfg/ip/if 2/ena/mask 255.255.255.0/addr 20.0.0.20/vl 2
>> # /cfg/ip/if 3/ena/mask 255.255.255.255/addr 20.0.0.21/vl 2
>> # /cfg/ip/route
>> # add 10.0.0.10 255.255.255.255 20.0.0.101 2
>> # add 10.0.0.11 255.255.255.255 20.0.0.102 3
>> # add 10.0.0.20 255.255.255.255 20.0.0.101 2
>> # add 10.0.0.21 255.255.255.255 20.0.0.102 3