Network Router User Manual

Web OS 10.0 Application Guide
332
Chapter 13: Firewall Load Balancing
212777-A, February 2002
4. Configure static routes on the primary dirty-side Web switch.
Four static routes are required:
n To primary clean-side IF 2 via Firewall 1 using dirty-side IF 2
n To primary clean-side IF 3 via Firewall 2 using dirty-side IF 3
n To secondary clean-side IF 2 via Firewall 1 using dirty-side IF 2
n To secondary clean-side IF 3 via Firewall 2 using dirty-side IF 3
NOTE – Remember, IF 2 is being used on all Web switches whenever routing through the top
firewall, and IF 3 is being used on all Web switches whenever routing through the lower fire-
wall.
The static route add command uses the following format:
add <destination address> <dest. mask> <gateway address> <source interface>
This example requires the following static route configuration:
NOTE – When defining static routes for FWLB, it is important to specify the source IP inter-
face numbers.
5. Make your changes take effect.
>> # /cfg/ip/frwd/route
>> # add 10.10.3.1 255.255.255.255 10.10.2.3 2
>> # add 10.10.3.2 255.255.255.255 10.10.2.4 3
>> # add 10.10.3.11 255.255.255.255 10.10.2.3 2
>> # add 10.10.3.12 255.255.255.255 10.10.2.4 3
>> # apply
>> # save
>> # /boot/reset