Network Router User Manual

Web OS 10.0 Application Guide
Chapter 6: Server Load Balancing
137
212777-A, February 2002
The following procedure can be used for configuring proxy IP addresses:
1. Disable server processing on affected switch ports.
When implementing proxies, switch ports can be reconfigured to disable server processing.
Referring to the Table 6-2 on page 126, the following revised port conditions are used:
The following commands are used to disable server processing on ports 1-3:
2. Add proxy IP addresses to the client ports.
Each client port requires a proxy IP address. Each proxy IP address must be unique on your
network. The following commands are used to configure client proxies:
The proxies are transparent to the user.
Table 6-4 Proxy Example: Port Usage
Port Host L4 Processing
1 Server A None
2 Server B None
3 Server C None
4 Back-end NFS server provides centralized Web content for all three
real servers. This port does not require Web switching features.
None
5 Client router A connects the switch to the Internet where all client
requests originate.
Client
6 Client router B also connects the switch to the Internet where all client
requests originate.
Client
>> # /cfg/slb/port 1 (Select switch port 1)
>> SLB port 1# server dis (Disable server processing on port 1)
>> SLB port 1# ../port 2 (Select switch port 2)
>> SLB port 2# server dis (Disable server processing on port 2)
>> SLB port 2# ../port 3 (Select switch port 3)
>> SLB port 3# server dis (Disable server processing on port 3)
>> # /cfg/slb/port 5 (Select network port 5)
>> SLB port 5# pip 200.200.200.68 (Set proxy IP address for client port 5)
>> SLB port 5# ../port 6 (Select network port 6)
>> SLB port 6# pip 200.200.200.69 (Set proxy IP address for client port 6)