Network Cables User Manual

206379-A
4-1
Chapter 4
Using the WOL Feature
You can use the Wake On LAN (WOL) feature to start up remote workstations
without end-user intervention. A BayStack 21 PCI 10/100 Adapter w/WOL must
be installed on each workstation that you want to start remotely. You must set up
each workstation prior to using the WOL feature.
Setting Up the Workstation
Perform the following tasks prior to using the WOL feature on a remote
workstation:
• Make sure the WOL connector is attached to the BayStack 21 network card
and to the motherboard of the workstation.
Refer to “Connecting the WOL Cable
” on page 2-3 for instructions.
• Place the workstation in sleep (or standby) mode, or turn the workstation off
completely.