Enterprise Edge M7324 Quick Reference Guide © 2000 Nortel Networks P0908514 Issue 03
Your Enterprise Edge M7324 Telephone Memory and line buttons are buttons with indicators for one touch dialing, feature operation or line access. Display shows the time, date, call information, and guides you. The lower line of the display is reserved for display button instructions. Display buttons Dial pad Volume control Feature button starts or ends a feature. Hold button Release button cancels active calls. Indicators appear beside lines and features.
Making and answering calls Answering calls Answering calls using the handset When your telephone rings, or º flashes beside an Intercom or line button: 1. Lift the handset. OR Press the button beside the flashing º before lifting the handset. Answering calls using Handsfree When your telephone rings, or º flashes beside an Intercom or line button: 1. Press ©. Making calls Depending upon the dialing mode programmed on your telephone, you may have to lift the handset before making a call.
Making and answering calls continued © This button operates your telephone’s built-in microphone and speaker. Your System Administrator can program Handsfree for your telephone. Switching between Handsfree and handset 1. Press © and replace the handset to switch to Handsfree. 2. Pick up the handset to switch back. Using Mute 1. Press © to turn the microphone OFF. 2. Press © again to turn the microphone ON. Making calls using Handsfree 1. Press ©instead of lifting the handset.
Programming memory buttons About memory buttons Memory buttons are the buttons with labels other than line or Handsfree buttons. Memory buttons store telephone numbers or feature codes to give you one-touch dialling or feature activation. You can change the function of a memory button by programming it with a new number or feature. If you have programmed a memory button with an extension number, the indicator comes on when the number is busy. Remember: Press ƒ•‚ to check a memory or line button.
Setting up the telephone Connecting the cords Connect to jack from distribution block Connect to receiver Page 5 Enterprise Edge M7324 Quick Feature Guide ATTENTION Before attempting to carry out any work on the telephone, ensure that the line cord is unplugged from the wall socket. To remove any of the cords, squeeze the release latch on the plug and gently pull the plug from the socket. Connect the handset cord to the jack labelled with the telephone icon and route the cord as shown.
