Enterprise Edge M7208 Quick Reference Guide © 2000 Nortel Networks P0908512 Issue 03
Your Enterprise Edge M7208 telephone Display shows the time, date, call information, and guides you. Indicators appear beside lines and features. Feature button starts or ends a feature. Release button cancels active calls. Hold button Dial pad Volume control Memory and line buttons are buttons with indicators for one touch dialing, feature operation or line access. Using Key Inquiry Check what is programmed on your memory keys. 1. 2. 3. 4. 5. Release all calls or lines with dial tone. Press ƒ•‚.
Making and answering calls Answering calls Answering calls using the handset When your telephone rings, or º flashes beside an Intercom or line key: 1. Lift the handset. OR Press the key beside the flashing º before lifting the handset. Answering calls using Handsfree When your telephone rings, or º flashes beside an Intercom or line key: 1. Press ©. Making calls Depending upon the dialling mode programmed on your telephone, you may have to lift the handset before making a call.
Making and answering calls continued © System Administrator can program Handsfree for your telephone. Switching between Handsfree and handset 1. Press © and replace the handset to switch to Handsfree. 2. Pick up the handset to switch back. Using Mute 1. Press © to turn the microphone OFF. 2. Press © again to turn the microphone ON. Making calls using Handsfree 1. Press © instead of lifting the handset.
Programming memory keys About memory keys Memory keys are the keys with indicators other than line or Handsfree keys. Memory keys store telephone numbers or feature codes to give you one-touch dialling or feature activation. You can change what a memory key does by just programming it with a new number or feature. You cannot program a line or Handsfree key. Remember: Press ƒ•‚ to check a memory or line key. Programming memory keys External Autodial 1. 2. 3. 4. 5. 6.
Setting up the telephone Connecting the cords ATTENTION Before attempting to carry out any work on the telephone, ensure that the line cord is unplugged from the wall socket. To remove any of the cords, squeeze the release latch on the plug and gently pull the plug from the socket. Connect to jack from distribution block Connect to receiver Page 5 Enterprise Edge M7208 Quick Reference Guide Connect the handset cord to the jack labelled with the telephone icon and route the cord as shown.
Setting up the telephone continued Mounting the telephone on the wall Page 6 Enterprise Edge M7208 Quick Reference Guide P0980512 Issue 03
