User manual

Installing and configuring Nortel IP Phones Page 405 of 466
Communication Server 1000E Installation and Commissioning
Connectivity and power requirements
Each Nortel IP Phone requires:
• a dedicated 10BaseT or 100BaseT or 10/100BaseT Ethernet interface
• a small desktop hub or switch if sharing an existing desktop Ethernet
connection with a PC.
• a local power supply appropriate for the voltage in the area or a Power
over LAN unit. (The Nortel IP Phone 2002 comes with a built-in 3-port
switch and is ready for LAN powering.)
Installation and configuration procedures
This chapter contains the following procedures:
• Procedure 93: "Configuring VoIP bandwidth management zones using
the CLI" on page 406
• Procedure 94: "Configuring virtual superloops" on page 408
• Procedure 95: "Configuring the IP Phones" on page 409
• Procedure 96: "Setting passwords for the administrator and temporary
IP Telephone Installer" on page 414
• Procedure 97: "Installing Nortel IP Phone hardware components" on
page 417
• Procedure 98: "Entering IP Telephone boot parameters using manual
configuration" on page 422
• Procedure 99: "Entering Nortel IP Phone boot parameters using full
DHCP parameters" on page 425
• Procedure 100: "Entering boot parameters using partial DHCP
parameters" on page 427
• Procedure 101: "Using Set-Based Installation" on page 430
• Procedure 102: "Configuring the IP Softphone 2050" on page 433
• Procedure 103: "Installing the USB Headset Kit" on page 434
• Procedure 104: "Installing the IP Softphone 2050 on your PC" on
page 434