User guide

Chapter 1 Telephone configuration overview 23
Telephone Features Programming Guide
Digital telephone installation
If you are connecting a Business Communications Manager digital telephone for the first time,
refer to the following illustrations and steps for installation instructions.
1 Disconnect the line cord from the wall socket before trying to carry out any work on the
telephone.
2 To remove any of the cords, press the release latch on the plug and carefully pull the plug from
the socket.
3 Connect the handset cord to the jack labeled with the telephone icon and route the cord as
shown.
4 If you are using a headset, route the cord along the channel in the base and connect the cord to
the telephone jack that is labeled with the headset icon.
5 Route the line cord through the support and connect the cord to the telephone jack that is
labeled with the jack icon.
6 Attach the support using either pair of slots. To raise the back of the telephone to its highest
position, use these slots.
7 When the above work is complete, plug the line cord back into the wall socket.
Figure 3 and Figure 4 show the T7316 peripheral connection points, and how to connect the
telephone to a wall jack.
Figure 3 T7316 telephone peripheral connections
Hold button Puts an active call on hold.
Release button Hangs up an active call or ends programming.
Table 1 Digital telephone button functions, refer to Figure 1 and Figure 2.
6
7