User's Manual

Chapter 5 Initializing the CallPilot Mini/CallPilot 150 45
CallPilot Mini/CallPilot 150 Installation and Maintenance Guide
You can now start programming the CallPilot parameters. For information about how to program
the CallPilot, refer to the CallPilot Set Up and Operation Guide.
7. Press CHNG
to toggle the settings between Y for Yes, or N for
No.
8. Press NEXT
.
When you choose N (No) for the enable Group List option,
steps 9 and 10 are not required and the system automatically
goes to step 11.
9. Press CHNG
to enter a new Group List leading digit.
The Group List leading digit can be any number from 0 to 9.
Special Mailbox numbers automatically begin with 1, so if
you select a Group List leading digit of 1, the Special
Mailboxes will begin with 2. The Group List Leading Digit
cannot be the same as the first number of any mailbox.
10. Press NEXT
.
11. Press CHNG
to toggle the settings between Y for Yes, or N for
No.
12. Press NEXT
.
13. Press CHNG
to toggle the setting between NVM and CP.
If you choose NVM, the mailbox users will see and hear
Norstar Voice Mail prompts when they use their mailboxes.
If you choose CP, the mailbox users will see and hear
CallPilot prompts when they use their mailboxes.
14. Press NEXT
.
15. Press OK
.
This message appears on the display.
Initialization takes about three seconds. When complete, the
display shows: System ready and Exit.
After the initialization programming is completed, the display
automatically returns to the time and date.
Group lists? Y
CHNG NEXT
Leading digit: 9
CHNG NEXT
CallPilot UI:Y
CHNG NEXT
Primary UI:NVM
CHNG NEXT
System config
RETRY OK
Configuring...
System ready
Exit