User's Manual

44 Chapter 5 Initializing the CallPilot Mini/CallPilot 150
P0990474 03
3 Press NEXT
to show the next Feature Code used by CallPilot. Record this code in Table 15 and
on the CallPilot Programming Record or the Call Center Programming Record.
4 Repeat step 3 until you reach the final Feature Code.
5 Press QUIT
to end this session.
Configuring the CallPilot 150 initial parameters
To configure the CallPilot 150 initial parameters:
1. Press ≤·°‹.
This is the default System Administration feature code. If
your system does not use the default feature codes, enter
the System Administration feature code you determined
earlier.
2. Enter ¤flfl‹›› (CONFIG) and press OK
.
3. Press CHNG
to toggle the settings between voicemail or
CallCenter.
If you choose voicemail, the voicemail application and 20
mailboxes are enabled.
If you choose CallCenter, the Call Center software and 10
agents are enabled.
4. Press NEXT
.
5. Press Y
if you want the display and voice prompts to be
available in two languages.
Press N
if you want the display and voice prompts to be
available in one language.
When you choose N (No) for the Bilingual option, step 6 is not
required and the system automatically goes to step 7.
6. Press the button for the language you want as the Primary
Language.
Pswd:
RETRY OK
App:voicemail
CHNG NEXT
Bilingual?
YES NO
Primary lang?
ENG FRE