User's Manual

38 Chapter 5 Initializing the CallPilot Mini/CallPilot 150
P0990474 03
Changing the IP address using an Ethernet crossover cable
Using an Ethernet crossover cable, you can connect the CallPilot Mini/CallPilot 150 to your
computer. With this connection, you can use CallPilot Manager to change the CallPilot Mini/
CallPilot 150 IP address before you connect it to the network.
To use an Ethernet crossover cable, your computer must be equipped with a 10/100 BaseT
Ethernet card and support TCP/IP protocol. Figure 5 shows the connections required.
Figure 5 Ethernet crossover cable
Connecting the Ethernet crossover cable
1 Shut down the computer.
2 Attach one end of the Ethernet crossover cable to the Ethernet port on the CallPilot Mini/
CallPilot 150.
3 Connect the other end of the cable to the network interface card on your computer.
4 Start the computer.
5 Use the Quick Install Wizard to initialize the CallPilot Mini/CallPilot 150.
For information about how to use the Quick Install Wizard, refer to “Running the Quick Install
Wizard” on page 39.
Note: If you do not have access to the CallPilot Mini/CallPilot 150 through the network,
you can use an Ethernet crossover cable to configure all of the CallPilot Mini/CallPilot
150 parameters.
Note: An Ethernet crossover cable is available as a separately available part. For
information about obtaining an Ethernet crossover cable, contact your Nortel Networks
supplier.
3TD+
6TD-
1RD+
2RD-
3TD+
6TD-
1RD+
2RD-