User's Manual

32 Chapter 5 Initializing the CallPilot Mini/CallPilot 150
P0990474 03
Assigning ACD Agents
All of the steps below are performed on the Meridian 1 PBX using a terminal connection.
1 At the main prompt type, LD 11.
2 Respond to the prompts according to Table 10.
Note: For any of the prompts not listed in the table below, press the Enter key to
accept the default value.
Table 10 Assigning ACD Agents
Prompt Response Comment
REQ NEW
TYPE 2616
TN 4 0 Type one of the Terminals Numbers (TNs) assigned to CallPilot Mini.
The TN shown (4 0) is an example only.
DES AGENT1 Type a name for this agent.
The name shown (AGENT1) is an example only.
CLS FLXA VCE WTA
CNDA DNDD
KEY 00 ACD 5666 0 5701 Type the ACD Queue number of the ACD Queue assigned to CallPilot
Mini. In the example shown, 5666 is the ACD Queue number.
Type the Agent Position ID number. You can enter any unique ID
number. In the example shown, 5701 is the Agent Position ID number.
KEY 01 SCR 5801 Type the Outbound Dial DN. You can use any unique DN.
In the example shown, 5801 is the Outbound Dial DN.
KEY 02 AO3
KEY 03 TRN
KEY 04 NRD
KEY 05 MIK
KEY 06 MCK
Note: For more information about how to add agents to an ACD Queue, refer to the
documentation that came with your Meridian 1 PBX.