User's Manual

Technical Configuration Guide for SNMP v2.0 December 2006
______________________________________________________________________________________________________
NORTEL External Distribution
18
For example, to add a SNMPv1 trap-receiver, enter the following assuming the Target Name is
TAddr1 and assuming you are using the default trap notify of trapTag and the default target-
param of TparamV1 for SNMPv1 traps:
• ERS-8606:5# config snmp-v3 target-addr create TAddr1 X.X.X.X:162 TparamV1
timeout 1500 retry 3 taglist trapTag mask 0xff:ff:00:00:00:00 mms 484
Where X.X.X.X is the IP-Address of your trap-receiver. Enter TparamV1 for SNMPv1 and
TparamV2 for SNMPv2c. For each subsequent trap receiver that you add, you must give it a new
target address, for example TAddr2, mgmtstation, etc.
The following is an example of adding an SNMP target address of 10.10.1.102 using the default
notification tag “trapTag” for SNMPv1 traps.
• ERS-8606:5# config snmp-v3 target-addr create TAddr1 10.10.1.102:162 TparamV1
timeout 1500 retry 3 taglist trapTag mask 0xff:ff:00:00:00:00 mms 484
NOTE: If you wish, you can also manually set the source IP address for all trap messages sent
by the ERS 8600. For example, you could create a circuit-less IP address and use this address
as the source IP for all traps generated. Please see section 4 for more details.
NOTE: You also configure the ERS 8600 to send authentication traps. Please see section 4 for
more details.
To delete a trap receiver, delete the target name, for example:
• ERS-8606:5# config snmp-v3 target-addr delete TAddr1
To view the trap receiver table, enter the following command:
• ERS-8606:5# config snmp-v3 target-addr info
================================================================================
Target Address Configuration
================================================================================
Target Name TDomain TAddress TMask
--------------------------------------------------------------------------------
TAddr1 ipv4 10.10.1.102:162 0xff:ff:00:0
0:00:00
================================================================================
Target Address Configuration
================================================================================
Target Name Timeout Retry TagList
Params MMS
--------------------------------------------------------------------------------
TAddr1 1500 3 trapTag
TparamV1 484
To view the SNMPv3 target parameters, enter the following command:
• ERS-8610:5# config snmp-v3 target-param info
================================================================================
Target Params Configuration
================================================================================
Target Name MP Model Security Name Sec
Level
--------------------------------------------------------------------------------
TparamV1 snmpv1 readview noAu
thNoPriv
TparamV2 snmpv2c readview noAu
thNoPriv