User's Manual
Table Of Contents
- Contents
- Preface
- The Command Line Interface
- First-Time Configuration
- Using the Setup Utility
- Setting Passwords
- Menu Basics
- The Information Menu
- Information Menu
- System Information
- Layer 2 Information
- Layer 3 Information
- IP Routing Information
- ARP Information
- BGP Information
- BGP Peer information
- BGP Summary information
- OSPF Information
- Routing Information Protocol Information
- IP Information
- IGMP Multicast Group Information
- IGMP Group Information
- IGMP Multicast Router Port Information
- IGMP Mrouter Information
- VRRP Information
- Quality of Service Information
- 802.1p Information
- Access Control List Information
- Link Status Information
- Port Information
- Logical Port to GEA Port Mapping
- Fiber Port SFP Status
- Information Dump
- The Statistics Menu
- The Configuration Menu
- Configuration Menu
- Viewing, Applying, and Saving Changes
- System Configuration
- Port Configuration
- Layer 2 Configuration
- 802.1x Configuration
- Rapid Spanning Tree Protocol/ Multiple Spanning Tree Protocol Configuration
- Common Internal Spanning Tree Configuration
- Spanning Tree Configuration
- GVRP Configuration
- GVRP Port Configuration
- Trunk Configuration
- IP Trunk Hash Configuration
- LACP Configuration
- Layer 2 Failover Configuration
- VLAN Configuration
- Protocol-based VLAN Configuration
- Private VLAN Configuration
- Layer 3 Configuration
- IP Interface Configuration
- Default Gateway Configuration
- IP Static Route Configuration
- IP Multicast Route Configuration
- ARP Configuration
- IP Forwarding Configuration
- Network Filter Configuration
- Routing Map Configuration
- Routing Information Protocol Configuration
- Open Shortest Path First Configuration
- Border Gateway Protocol Configuration
- IGMP Configuration
- Domain Name System Configuration
- Bootstrap Protocol Relay Configuration
- VRRP Configuration
- Quality of Service Configuration
- Access Control List Configuration
- Port Mirroring Configuration
- Setup
- Dump
- Saving the Active Switch Configuration
- Restoring the Active Switch Configuration
- The Operations Menu
- The Boot Options Menu
- The Maintenance Menu
- Alteon OS Syslog Messages
- Alteon OS SNMP Agent
- Glossary
- Index
43W7774, May 2007 365
Appendix B
Alteon OS SNMP Agent
The Alteon OS SNMP agent supports SNMP version 3. Security is provided through SNMP
community strings. The default community strings are “public” for SNMP GET operation and
“private” for SNMP SET operation. The community string can be modified only through the
Command Line Interface (CLI). Alteon WebSystems is registered as Vendor 1872. Detailed
SNMP MIBs and trap definitions of the Alteon OS SNMP agent are contained in the following
Alteon OS enterprise MIB document:
GbESM-10U-2223.mib
Users may specify up to two trap hosts for receiving SNMP Traps. The agent will send the
SNMP Trap to the specified hosts when appropriate. Traps are not sent if there is no host spec-
ified.
Alteon OS SNMP agent supports the following standard MIBs:
rfc1213.mib
rfc1215.mib
rfc1493.mib
rfc1573.mib
rfc1643.mib
rfc1757.mib
rfc1907.mib
rfc2037.mib
rfc2571 .mib
rfc2572.mib
rfc2573.mib
rfc2574.mib
rfc2575.mib
rfc2576.mib