User's Manual
Table Of Contents
- Contents
- Preface
- The Command Line Interface
- First-Time Configuration
- Using the Setup Utility
- Setting Passwords
- Menu Basics
- The Information Menu
- Information Menu
- System Information
- Layer 2 Information
- Layer 3 Information
- IP Routing Information
- ARP Information
- BGP Information
- BGP Peer information
- BGP Summary information
- OSPF Information
- Routing Information Protocol Information
- IP Information
- IGMP Multicast Group Information
- IGMP Group Information
- IGMP Multicast Router Port Information
- IGMP Mrouter Information
- VRRP Information
- Quality of Service Information
- 802.1p Information
- Access Control List Information
- Link Status Information
- Port Information
- Logical Port to GEA Port Mapping
- Fiber Port SFP Status
- Information Dump
- The Statistics Menu
- The Configuration Menu
- Configuration Menu
- Viewing, Applying, and Saving Changes
- System Configuration
- Port Configuration
- Layer 2 Configuration
- 802.1x Configuration
- Rapid Spanning Tree Protocol/ Multiple Spanning Tree Protocol Configuration
- Common Internal Spanning Tree Configuration
- Spanning Tree Configuration
- GVRP Configuration
- GVRP Port Configuration
- Trunk Configuration
- IP Trunk Hash Configuration
- LACP Configuration
- Layer 2 Failover Configuration
- VLAN Configuration
- Protocol-based VLAN Configuration
- Private VLAN Configuration
- Layer 3 Configuration
- IP Interface Configuration
- Default Gateway Configuration
- IP Static Route Configuration
- IP Multicast Route Configuration
- ARP Configuration
- IP Forwarding Configuration
- Network Filter Configuration
- Routing Map Configuration
- Routing Information Protocol Configuration
- Open Shortest Path First Configuration
- Border Gateway Protocol Configuration
- IGMP Configuration
- Domain Name System Configuration
- Bootstrap Protocol Relay Configuration
- VRRP Configuration
- Quality of Service Configuration
- Access Control List Configuration
- Port Mirroring Configuration
- Setup
- Dump
- Saving the Active Switch Configuration
- Restoring the Active Switch Configuration
- The Operations Menu
- The Boot Options Menu
- The Maintenance Menu
- Alteon OS Syslog Messages
- Alteon OS SNMP Agent
- Glossary
- Index
Alteon OS Command Reference
Alteon OS Syslog Messages
35743W7774, May 2007
LOG_ERROR (continued)
PORT_MIRR Port Mirroring changes are not applied
CLI Broadcast address for IP interface <interface_id> is invalid
CLI IP Interfaces <interface_id> and <interface_id> are on the same subnet
MGMT Unapplied changes reverted
MGMT Unsaved changes reverted
CLI SNMP source trap interface <IF> is not enabled
CLI Password already taken
CLI Radius is already turned ON
CLI Cannot ena/dis primary admin user
CLI Cannot change primary admin COS
CLI Cannot change primary admin username
CLI Cannot delete primary admin
CLI Error: Enabled user <user> has no username
CLI Error: Enabled user <user> has no password
CLI New combination of Bridge Timers for STG <group> is invalid
CLI Need maxage <= 2*(frwd-1) and maxage >= 2*(hello+1)
CLI Multiple VLAN members in non default STG <group>
CLI Duplicate VLAN members in STGs <gr1> and <gr2>
CLI VRRP hot-standby port (<port>) is part of a STG (<group>) with STP
turned on
CLI Error writing active config to FLASH!
- Another save is in progress -OR-
- Configuration is too large -OR-
- Unknown error