User's Manual
Table Of Contents
- Contents
- Preface
- The Command Line Interface
- First-Time Configuration
- Using the Setup Utility
- Setting Passwords
- Menu Basics
- The Information Menu
- Information Menu
- System Information
- Layer 2 Information
- Layer 3 Information
- IP Routing Information
- ARP Information
- BGP Information
- BGP Peer information
- BGP Summary information
- OSPF Information
- Routing Information Protocol Information
- IP Information
- IGMP Multicast Group Information
- IGMP Group Information
- IGMP Multicast Router Port Information
- IGMP Mrouter Information
- VRRP Information
- Quality of Service Information
- 802.1p Information
- Access Control List Information
- Link Status Information
- Port Information
- Logical Port to GEA Port Mapping
- Fiber Port SFP Status
- Information Dump
- The Statistics Menu
- The Configuration Menu
- Configuration Menu
- Viewing, Applying, and Saving Changes
- System Configuration
- Port Configuration
- Layer 2 Configuration
- 802.1x Configuration
- Rapid Spanning Tree Protocol/ Multiple Spanning Tree Protocol Configuration
- Common Internal Spanning Tree Configuration
- Spanning Tree Configuration
- GVRP Configuration
- GVRP Port Configuration
- Trunk Configuration
- IP Trunk Hash Configuration
- LACP Configuration
- Layer 2 Failover Configuration
- VLAN Configuration
- Protocol-based VLAN Configuration
- Private VLAN Configuration
- Layer 3 Configuration
- IP Interface Configuration
- Default Gateway Configuration
- IP Static Route Configuration
- IP Multicast Route Configuration
- ARP Configuration
- IP Forwarding Configuration
- Network Filter Configuration
- Routing Map Configuration
- Routing Information Protocol Configuration
- Open Shortest Path First Configuration
- Border Gateway Protocol Configuration
- IGMP Configuration
- Domain Name System Configuration
- Bootstrap Protocol Relay Configuration
- VRRP Configuration
- Quality of Service Configuration
- Access Control List Configuration
- Port Mirroring Configuration
- Setup
- Dump
- Saving the Active Switch Configuration
- Restoring the Active Switch Configuration
- The Operations Menu
- The Boot Options Menu
- The Maintenance Menu
- Alteon OS Syslog Messages
- Alteon OS SNMP Agent
- Glossary
- Index
Alteon OS Command Reference
330
The Boot Options Menu 43W7774, May 2007
/boot
Boot Menu
Each of these options is discussed in greater detail in the following sections.
Scheduled Reboot of the Switch
This feature allows the switch administrator to schedule a reboot to occur at a particular time in
future. This feature is particularly helpful if the user needs to perform switch upgrades during
off-peak hours. You can set the reboot time, cancel a previously scheduled reboot, and check
the time of the currently set reboot schedule with the help of the following sub-menu:
/boot/sched
Scheduled Reboot Menu
[Boot Options Menu]
sched - Scheduled Switch Reset Menu
image - Select software image to use on next boot
conf - Select config block to use on next boot
mode - Select CLI mode to use on next boot
prompt - Prompt for selectable boot mode
gtimg - Download new software image via TFTP
ptimg - Upload selected software image via TFTP
reset - Reset switch [WARNING: Restarts Spanning Tree]
cur - Display current boot options
[Boot Schedule Menu]
set - Set switch reset time
cancel - Cancel pending switch reset
cur - Display current switch reset schedule