User's Manual
Table Of Contents
- Contents
- Preface
- The Command Line Interface
- First-Time Configuration
- Using the Setup Utility
- Setting Passwords
- Menu Basics
- The Information Menu
- Information Menu
- System Information
- Layer 2 Information
- Layer 3 Information
- IP Routing Information
- ARP Information
- BGP Information
- BGP Peer information
- BGP Summary information
- OSPF Information
- Routing Information Protocol Information
- IP Information
- IGMP Multicast Group Information
- IGMP Group Information
- IGMP Multicast Router Port Information
- IGMP Mrouter Information
- VRRP Information
- Quality of Service Information
- 802.1p Information
- Access Control List Information
- Link Status Information
- Port Information
- Logical Port to GEA Port Mapping
- Fiber Port SFP Status
- Information Dump
- The Statistics Menu
- The Configuration Menu
- Configuration Menu
- Viewing, Applying, and Saving Changes
- System Configuration
- Port Configuration
- Layer 2 Configuration
- 802.1x Configuration
- Rapid Spanning Tree Protocol/ Multiple Spanning Tree Protocol Configuration
- Common Internal Spanning Tree Configuration
- Spanning Tree Configuration
- GVRP Configuration
- GVRP Port Configuration
- Trunk Configuration
- IP Trunk Hash Configuration
- LACP Configuration
- Layer 2 Failover Configuration
- VLAN Configuration
- Protocol-based VLAN Configuration
- Private VLAN Configuration
- Layer 3 Configuration
- IP Interface Configuration
- Default Gateway Configuration
- IP Static Route Configuration
- IP Multicast Route Configuration
- ARP Configuration
- IP Forwarding Configuration
- Network Filter Configuration
- Routing Map Configuration
- Routing Information Protocol Configuration
- Open Shortest Path First Configuration
- Border Gateway Protocol Configuration
- IGMP Configuration
- Domain Name System Configuration
- Bootstrap Protocol Relay Configuration
- VRRP Configuration
- Quality of Service Configuration
- Access Control List Configuration
- Port Mirroring Configuration
- Setup
- Dump
- Saving the Active Switch Configuration
- Restoring the Active Switch Configuration
- The Operations Menu
- The Boot Options Menu
- The Maintenance Menu
- Alteon OS Syslog Messages
- Alteon OS SNMP Agent
- Glossary
- Index
Alteon OS Command Reference
306
The Configuration Menu 43W7774, May 2007
/cfg/qos/dscp
DSCP Configuration
Use this menu map the DiffServ Code Point (DSCP) value of incoming packets to a new value,
or to an 802.1p priority value.
[dscp Menu]
dscp - Remark DSCP value to a new DSCP value
prio - Remark DSCP value to a 802.1p priority
on - Globally turn DSCP remarking ON
off - Globally turn DSCP remarking OFF
cur - Display current DSCP remarking configuration
Table 6-100 DSCP Menu Options (/cfg/qos/dscp)
Command Syntax and Usage
dscp <0-63> <0-63>
Maps the initial DiffServ Code Point (DSCP) value to a new value. Enter the DSCP value (0-63) of
incoming packets, followed by the new value.
prio <dscp (0-63)> <priority (0-7)>
Maps the DiffServ Code point value to an 802.1p priority value. Enter the DSCP value, followed
by the corresponding 802.1p value.
on
Turns on DSCP re-marking globally.
off
Turns off DSCP re-marking globally.
cur
Displays the current DSCP parameters.