User's Manual
Table Of Contents
- Contents
- Preface
- The Command Line Interface
- First-Time Configuration
- Using the Setup Utility
- Setting Passwords
- Menu Basics
- The Information Menu
- Information Menu
- System Information
- Layer 2 Information
- Layer 3 Information
- IP Routing Information
- ARP Information
- BGP Information
- BGP Peer information
- BGP Summary information
- OSPF Information
- Routing Information Protocol Information
- IP Information
- IGMP Multicast Group Information
- IGMP Group Information
- IGMP Multicast Router Port Information
- IGMP Mrouter Information
- VRRP Information
- Quality of Service Information
- 802.1p Information
- Access Control List Information
- Link Status Information
- Port Information
- Logical Port to GEA Port Mapping
- Fiber Port SFP Status
- Information Dump
- The Statistics Menu
- The Configuration Menu
- Configuration Menu
- Viewing, Applying, and Saving Changes
- System Configuration
- Port Configuration
- Layer 2 Configuration
- 802.1x Configuration
- Rapid Spanning Tree Protocol/ Multiple Spanning Tree Protocol Configuration
- Common Internal Spanning Tree Configuration
- Spanning Tree Configuration
- GVRP Configuration
- GVRP Port Configuration
- Trunk Configuration
- IP Trunk Hash Configuration
- LACP Configuration
- Layer 2 Failover Configuration
- VLAN Configuration
- Protocol-based VLAN Configuration
- Private VLAN Configuration
- Layer 3 Configuration
- IP Interface Configuration
- Default Gateway Configuration
- IP Static Route Configuration
- IP Multicast Route Configuration
- ARP Configuration
- IP Forwarding Configuration
- Network Filter Configuration
- Routing Map Configuration
- Routing Information Protocol Configuration
- Open Shortest Path First Configuration
- Border Gateway Protocol Configuration
- IGMP Configuration
- Domain Name System Configuration
- Bootstrap Protocol Relay Configuration
- VRRP Configuration
- Quality of Service Configuration
- Access Control List Configuration
- Port Mirroring Configuration
- Setup
- Dump
- Saving the Active Switch Configuration
- Restoring the Active Switch Configuration
- The Operations Menu
- The Boot Options Menu
- The Maintenance Menu
- Alteon OS Syslog Messages
- Alteon OS SNMP Agent
- Glossary
- Index
Alteon OS Command Reference
270
The Configuration Menu 43W7774, May 2007
/cfg/l3/ospf/if <interface number>
OSPF Interface Configuration
disable
Disables the OSPF summary range.
delete
Deletes the OSPF summary range.
current
Displays the current OSPF summary range.
[OSPF Interface 1 Menu]
aindex - Set area index
prio - Set interface router priority
cost - Set interface cost
hello - Set hello interval in seconds
dead - Set dead interval in seconds
trans - Set transit delay in seconds
retra - Set retransmit interval in seconds
key - Set authentication key
mdkey - Set MD5 key ID
enable - Enable interface
disable - Disable interface
delete - Delete interface
cur - Display current OSPF interface configuration
Table 6-70 OSPF Interface Configuration Menu Options (/cfg/l3/ospf/if)
Command Syntax and Usage
aindex <area index (0-2)>
Configures the OSPF area index.
prio <priority value (0-255)>
Configures the priority value for the GbE Switch Module’s OSPF interfaces.
(A priority value of 255 is the highest and 1 is the lowest. A priority value of 0 specifies that the
interface cannot be used as Designated Router (DR) or Backup Designated Router (BDR).)
cost <cost value (1-65535)>
Configures cost set for the selected path—preferred or backup. Usually the cost is inversely pro-
portional to the bandwidth of the interface. Low cost indicates high bandwidth.
Table 6-69 OSPF Summary Range Configuration Menu Options (/cfg/l3/ospf/range)
Command Syntax and Usage