User's Manual
Table Of Contents
- Contents
- Preface
- The Command Line Interface
- First-Time Configuration
- Using the Setup Utility
- Setting Passwords
- Menu Basics
- The Information Menu
- Information Menu
- System Information
- Layer 2 Information
- Layer 3 Information
- IP Routing Information
- ARP Information
- BGP Information
- BGP Peer information
- BGP Summary information
- OSPF Information
- Routing Information Protocol Information
- IP Information
- IGMP Multicast Group Information
- IGMP Group Information
- IGMP Multicast Router Port Information
- IGMP Mrouter Information
- VRRP Information
- Quality of Service Information
- 802.1p Information
- Access Control List Information
- Link Status Information
- Port Information
- Logical Port to GEA Port Mapping
- Fiber Port SFP Status
- Information Dump
- The Statistics Menu
- The Configuration Menu
- Configuration Menu
- Viewing, Applying, and Saving Changes
- System Configuration
- Port Configuration
- Layer 2 Configuration
- 802.1x Configuration
- Rapid Spanning Tree Protocol/ Multiple Spanning Tree Protocol Configuration
- Common Internal Spanning Tree Configuration
- Spanning Tree Configuration
- GVRP Configuration
- GVRP Port Configuration
- Trunk Configuration
- IP Trunk Hash Configuration
- LACP Configuration
- Layer 2 Failover Configuration
- VLAN Configuration
- Protocol-based VLAN Configuration
- Private VLAN Configuration
- Layer 3 Configuration
- IP Interface Configuration
- Default Gateway Configuration
- IP Static Route Configuration
- IP Multicast Route Configuration
- ARP Configuration
- IP Forwarding Configuration
- Network Filter Configuration
- Routing Map Configuration
- Routing Information Protocol Configuration
- Open Shortest Path First Configuration
- Border Gateway Protocol Configuration
- IGMP Configuration
- Domain Name System Configuration
- Bootstrap Protocol Relay Configuration
- VRRP Configuration
- Quality of Service Configuration
- Access Control List Configuration
- Port Mirroring Configuration
- Setup
- Dump
- Saving the Active Switch Configuration
- Restoring the Active Switch Configuration
- The Operations Menu
- The Boot Options Menu
- The Maintenance Menu
- Alteon OS Syslog Messages
- Alteon OS SNMP Agent
- Glossary
- Index
Alteon OS Command Reference
234
The Configuration Menu 43W7774, May 2007
/cfg/l2/gvrp/port
GVRP Port Configuration
Use the following commands to configure GVRP settings for the port.
off
Globally turns GVRP off. With GVRP off, the switch does not process GPDUs.
When you turn GVRP off, existing dynamic VLANs are deleted.
cur
Display current GVRP configuration.
[GVRP Port EXT2 Menu]
setreg - Set learning GPDU for registrar of this port
setapp - Set sending GPDU from applicant of this port
ena - Enable GVRP support for this port
dis - Disable GVRP support for this port
cur - Display current GVRP port parameters
Table 6-41 GVRP Port Menu Options (/cfg/l2/gvrp/port x)
Command Syntax and Usage
setreg normal|block
Configures GPDU learning for the port’s GVRP registrar, as follows:
Normal: The registrar listens for GPDUs, and learns GVRP attributes from other devices on the
network.
Block: The registrar does not listen for GPDUs from other devices.
setapp normal|block
Configures GPDU sending for the port’s GVRP applicant, as follows:
Normal: The applicant sends GPDUs to other devices on the network.
Block: The applicant does not send GPDUs to other devices.
ena
Enables GVRP on the port.
dis
Disables GVRP on the port.
cur
Display current GVRP port configuration.
Table 6-40 GVRP Menu Options (/cfg/l2/gvrp)
Command Syntax and Usage