User's Manual
Table Of Contents
- Contents
- Preface
- The Command Line Interface
- First-Time Configuration
- Using the Setup Utility
- Setting Passwords
- Menu Basics
- The Information Menu
- Information Menu
- System Information
- Layer 2 Information
- Layer 3 Information
- IP Routing Information
- ARP Information
- BGP Information
- BGP Peer information
- BGP Summary information
- OSPF Information
- Routing Information Protocol Information
- IP Information
- IGMP Multicast Group Information
- IGMP Group Information
- IGMP Multicast Router Port Information
- IGMP Mrouter Information
- VRRP Information
- Quality of Service Information
- 802.1p Information
- Access Control List Information
- Link Status Information
- Port Information
- Logical Port to GEA Port Mapping
- Fiber Port SFP Status
- Information Dump
- The Statistics Menu
- The Configuration Menu
- Configuration Menu
- Viewing, Applying, and Saving Changes
- System Configuration
- Port Configuration
- Layer 2 Configuration
- 802.1x Configuration
- Rapid Spanning Tree Protocol/ Multiple Spanning Tree Protocol Configuration
- Common Internal Spanning Tree Configuration
- Spanning Tree Configuration
- GVRP Configuration
- GVRP Port Configuration
- Trunk Configuration
- IP Trunk Hash Configuration
- LACP Configuration
- Layer 2 Failover Configuration
- VLAN Configuration
- Protocol-based VLAN Configuration
- Private VLAN Configuration
- Layer 3 Configuration
- IP Interface Configuration
- Default Gateway Configuration
- IP Static Route Configuration
- IP Multicast Route Configuration
- ARP Configuration
- IP Forwarding Configuration
- Network Filter Configuration
- Routing Map Configuration
- Routing Information Protocol Configuration
- Open Shortest Path First Configuration
- Border Gateway Protocol Configuration
- IGMP Configuration
- Domain Name System Configuration
- Bootstrap Protocol Relay Configuration
- VRRP Configuration
- Quality of Service Configuration
- Access Control List Configuration
- Port Mirroring Configuration
- Setup
- Dump
- Saving the Active Switch Configuration
- Restoring the Active Switch Configuration
- The Operations Menu
- The Boot Options Menu
- The Maintenance Menu
- Alteon OS Syslog Messages
- Alteon OS SNMP Agent
- Glossary
- Index
Alteon OS Command Reference
220
The Configuration Menu 43W7774, May 2007
svrtmout <1-65535>
Sets the time, in seconds, the authenticator waits for a response from the RADIUS server before
declaring an authentication timeout. The default value is 30 seconds.
The time interval between transmissions of the RADIUS Access-Request packet containing
the supplicant’s (client’s) EAP-Response packet is determined by the current setting of
/cfg/sys/radius/timeout (default is 3 seconds).
maxreq <1-10>
Sets the maximum number of times the authenticator retransmits an EAP-Request packet to the
supplicant (client). The default value is 2.
raperiod <1-604800>
Sets the time, in seconds, the authenticator waits before re-authenticating a supplicant (client)
when periodic re-authentication is enabled. The default value is 3600 seconds.
reauth on|off
Sets the re-authentication status to on or off. The default value is off.
default
Resets the 802.1x port parameters to their default values.
global
Applies current global 802.1x configuration parameters to the port.
cur
Displays current 802.1x port parameters.
Table 6-32 802.1x Port Configuration Menu Options (/cfg/l2/8021x/port)
Command Syntax and Usage