User manual

68 Chapter 5 Contivity 600 Option Installation
302283-D Rev 00
To install LAN or WAN cards you must:
1
Remove the power cable.
2
Remove all signal cables.
3
Remove the four screws on the bottom of the switch.
4
Slide the inner chassis out of the casing.
5
Unscrew the PCI interface bracket screw and remove the PCI interface card or
blank PCI bracket.
6
Install a new PCI interface, being careful to completely press the card into the
PCI connector on the mother board.
7
Replace the chassis (along the guide rails) in the outer casing.
8
Replace the bottom screws.
9
Reconnect the power cord to turn the switch back on.
This procedure is detailed in the steps that follow.