User manual

Configuring APs 223
Nortel WLAN—Security Switch 2300 Series Configuration Guide
transmit-rates 802.11a:
• mandatory:
6.0,12.0,24.0
• beacon-rate: 6.0
• multicast-rate:
auto
• disabled: none
802.11b:
• mandatory:
1.0,2.0
• beacon-rate: 2.0
• multicast-rate:
auto
• disabled: none
802.11g:
• mandatory:
1.0,2.0,5.5,11.0
• beacon-rate: 2.0
• multicast-rate:
auto
• disabled: none
Accepts associations only from clients that
support one of the mandatory rates.
Sends beacons at the specified rate
(6 Mbps for 802.11a, 2 Mbps for 802.11b/
g).
Sends multicast data at the highest rate
that can reach all clients connected to the
radio.
Accepts frames from clients at all valid
data rates. (No rates are disabled by
default.)
user-idle-timeout 180 Allows a client to remain idle for 180
seconds (3 minutes) before WSS Software
changes the client’s session to the
Disassociated state.
web-portal-acl portalacl
Note: This is the
default only if the
fallthru type on the
service profile has
been set to
web-portal.
Otherwise, the value
is unconfigured.
If set to portalacl and the service profile
fallthru is set to web-portal, radios use the
portalacl ACL to filter traffic for Web
Portal users during authentication.
If the fallthru type is web-portal but
web-portal-acl is set to an ACL other
than portalacl, the other ACL is used.
If the fallthru type is not web-portal,
radios do not use the web-portal-acl
setting.
web-portal-form Not configured For Web Portal Web-based AAA users,
serves the default login web page or, if
configured, the SSID-specific login web
page.
web-portal-session-
timeout
5 Allows a Web Portal Web-based AAA
session to remain in the Deassociated state
5 seconds before being terminated
automatically.
Table 2: Defaults for service profile parameters (continued)
Parameter Default Value
Radio Behavior When Parameter Set
To Default Value