Network Device Maintenance and Diagnostics

June 2007 Replacing basic chassis components
1005r Server Maintenance and Diagnostics 107
1 Loosen the captive screws (A) on both sides of the front bezel. The
screws cannot be removed from the front bezel. Refer to Figure 16
on page 106.
2 Hold the front bezel by the captive screws and lift it toward you.
Place it in a secure location while you service the server.
To replace the front bezel
When the CallPilot server maintenance is complete, replace the front
bezel.
1 Align the captive screws on the front bezel with the threaded holes
in the front panel.
2 Tighten the captive screws.
.
CAUTION
Risk of equipment damage
Support the front bezel while loosening the captive screws as
the front bezel is not held onto the front panel with another
mechanism.