User's Manual

Voice Gateway Media Card maintenance using OTM 2.2 Page 803 of 910
IP Line Description, Installation and Maintenance
19 In the OTM IP Telephony window, select View > Refresh and verify that
the replacement Voice Gateway Media Card state is showing
“Unequipped.”
End of Procedure
Replace a Follower Voice Gateway Media Card
Follow the steps in Procedure 113 to replace a Follower Voice Gateway
Media Card.
Procedure 113
Replacing a Follower Voice Gateway Media Card
1 Locate the faulty card in the OTM IP Telephony database by the TN, MAC
address, and IP address.
2 Disable the faulty Voice Gateway Media Card in LD 32 with the DISI
command. The system displays “NPR0011” when the card has been
completely disabled by the DISI command.
3 Use the disiTPS command at the IPL> CLI to disable the LTPS on the
faulty Voice Gateway Media Card.
Note: This forces all IP Phones registered on this card to reregister. If
there are sufficient resources, this can take up to several minutes. If there
are not sufficient resources, IP Phones can remain unregistered
indefinitely.
4 Use the isetShow command to monitor the status of the card and the
reregistration of the IP Phones. The Voice Gateway Media Card card is
completely disabled when there are no IP Phones registered on the card.
5 Remove the faulty Voice Gateway Media Card from the system.
6 In the OTM Navigator, select the Services folder. Double-click on the IP
Telephony icon. The IP Telephony window opens. Select the node in the
upper part of the window.
7 Click on Leader 0 or any Voice Gateway Media Card in the node.
8 Click Configuration > Node > Properties. The Node Properties window
opens.
9 Click the Configuration tab.
10 Select the card to be replaced.